Latest Blade 450 Swash Leveling Tool Blade 400 450 3D 450 X # BLH1690A
Tech Note:
- Disconnect the motor from the ESC by disconnecting any two wires between the motor and ESC
- Disconnect all the linkages from the swashplate
- Power on your transmitter
- Enable idle up
- Put the throttle stick to center position
- Observe the left and right servo arms and adjust your subtrim so that they are level
- Observe the elevator control arm (behind the motor) and adjust your subtrim so that it is level
- Slide the swash leveling tool under the swashplate as shown in the photos
- Place the swashplate flat on the tool
- Adjust the linkages such that the swashplate remains flat when attached
- Once all linkages are attached, disconnect the battery from the ESC
- Carefully slide the swashplate up and remove the swash leveling tool
- Disengage idle up on your transmitter and power it off
- Reconnect the motor wires to the ESC
- Now go fly!